2017 Honda CR-V Splash Guard Set – 08P00-TLA-100

What customers say about 2017 Honda CR-V Splash Guard Set – 08P00-TLA-100?

1. 2 of 2 people found the following review helpful

   
   Instructions are helpful…., June 6, 2017

   By 

   rjp (Texas) –

   Verified Purchase(What’s this?)

   This review is from: 2017 Honda CR-V Splash Guard Set – 08P00-TLA-100

   They fit as expected however my set did not include instructions. See pics. The idea that a stubby screwdriver would do this without removing the tires is not quite right, especially for the back wheels. I bought a Craftsman mini 15 degree offset ratcheting screwdriver which is the way to go. The offset helps on a tight inside screw in front and the leverage that you get is helpful for several of the screws. I found the instructions online. Finally, three spring clips/nuts are used on each splash guard in the back, two are large and one is small. It would have been better to have an extra small spring nut for each back wheel well. If you have time before installing, you might take one of the supplied small clips down to the hardware store and pickup two more.

   

   Help other customers find the most helpful reviews 

   Was this review helpful to you? 
   

   
   |

    Comment

2. 2 of 2 people found the following review helpful

   
   Fit perfect on our 2017 CRV Touring., May 25, 2017

   By 

   LBCTX –

   Verified Purchase(What’s this?)

   This review is from: 2017 Honda CR-V Splash Guard Set – 08P00-TLA-100

   Fit perfect on our 2017 CRV Touring. Probably took 20 min to do all four. All parts needed were supplied except stubby screwdriver and pushpin.

   Help other customers find the most helpful reviews 

   Was this review helpful to you? 
   

   
   |

    Comment

3. 1 of 1 people found the following review helpful

   
   Perfect fit, May 18, 2017

   By 

   Melissa santiago –

   Verified Purchase(What’s this?)

   This review is from: 2017 Honda CR-V Splash Guard Set – 08P00-TLA-100

   These are original equipment and fit perfectly. Instructions state to use a stubby (very short) screwdriver but i did not have enough clearance. I used a small ratcheting wrench with a phillip bit and was able to complete the job. Took me about 20 minutes to install all four.

   Help other customers find the most helpful reviews 

   Was this review helpful to you? 
   

   
   |

    Comment