Carrito
Carrito: $ 0.00
Home » Silenciador » DEI 010121 Black 2″ Exhaust Wrap – 15′
webrep 4.5
$ 12.66
DEI 010121 Black 2″ Exhaust Wrap – 15′

DEI 010121 Black 2″ Exhaust Wrap – 15′


Precio Reg. $ 16.88
Precio: $ 12.66
* Por tiempo limitado, Compre YA!
Ahorra $ 4,22 ( 25,00% )

"El precio más barato en DEI 010121 Black 2″ Exhaust Wrap – 15′ de amazon.com. Envío Rápido y Gratis. Antes de comprar, no olvide comparar precios nuevamente en amazon.com. Agregue al carrito mientras dura el inventario!"

DEI 010121 Black 2" Exhaust Wrap - 15'

DEI 010121 Black 2
  • 2" wide and 15' long
  • Reduce under hood temperatures a realistic 50%
  • Improves horsepower and withstands 1200° F direct / 2000° F radiant
  • Added durability and heat retention
  • Universal application
Wrapping headers and down pipes is an important first step in controlling unwanted underhood radiant heat. Keeping exhaust gases hotter within the exhaust system helps in decreasing exhaust density and increases exhaust flow. This improves exhaust scavenging resulting in cooler air intake temperatures for an improvement in performance and a gain in horsepower. Design Engineering stainless steel Locking Ties are the perfect way to fasten exhaust wrap for a easy, clean and professional installation.

Precio de lista: $ 16.88 Precio: $ 12.66

What customers say about DEI 010121 Black 2″ Exhaust Wrap – 15′?

  1. 13 of 13 people found the following review helpful
    5.0 out of 5 stars
    Good stuff, October 19, 2012
    By 

    Verified Purchase(What’s this?)
    This review is from: DEI 010121 Black 2″ Exhaust Wrap – 15′ (Automotive)
    There’s just enough in this 15′ roll to do one header pipe. Looks nice, easy to install after soaking in water.

    Two things to note:
    1) it will drip black crud everywhere after you get it wet.
    2) ends unravel very easily, be cautious. Fold over the end when wrapping your pipe, then clamp it down and it will be fine.

    0

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  2. 4 of 4 people found the following review helpful
    5.0 out of 5 stars
    I say great, July 5, 2013
    By 
    Dragonwort Castle
    (TOP 1000 REVIEWER)
      
    (VINE VOICE)
      

    Verified Purchase(What’s this?)
    This review is from: DEI 010121 Black 2″ Exhaust Wrap – 15′ (Automotive)
    This was ordered for a whole-house propane run generator (Winco/ONAN 25kw). The original 14year old wrapping was falling off and I could see red glowing pipes. I found out all exhaust pipes glow and people rarely know it, but the wrapping is important to keep the internal heat up for better combustion and the external intense heat localized to not fry other things (vacuum lines, hydrolics, wires, etc.). Head tempertures run about 700-900 degrees F so it is best to wrap them. This is fiberglass so you SHOULD wear a mask, goggles, and gloves. It has been so hot here I did not use gloves and did not notice and fiberglass in my hands like with house insullation. You are not supposed to soak it in water, like the old asbestos type. The instructions recommend wrapping every 1/4 width but I was told half is normal (I bought 2″ x 15′ and used 2 1/2 rolls). It needs to be started so use a stainless steel tie (I bought them from the same company on Amazon). They are much like SS zip ties and are also great; 8 pack) or it will keep unwrapping as you pull. Wrap it firmly but you will not be able to get it tight until you wrap the next half over the first. Be aware this smokes a lot when you first heat it (start the engine); if it is in a ventilated generator room/shed, you cannot breath and it will look like the shed is on fire with all of the smoke. It just heats off the chemicals on the wrap. Overall, it was a tricky, time-consuming, but a successful project. I think these pipes were factory wrapped and installed later in the process as they did too neat of a job and covered it in places blocked by other objects for me (like mounting bolts and cooling fins). Seems to work well. The old wrap was brittle and falling off. It was past time, but, I rarely open the sides to see it in action. Take the time to do it right, and, check your pipes regurlarly for need. Hope this helps someone.

    0

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  3. 5 of 5 people found the following review helpful
    5.0 out of 5 stars
    Finally quiet, June 3, 2012
    Verified Purchase(What’s this?)
    This review is from: DEI 010121 Black 2″ Exhaust Wrap – 15′ (Automotive)
    After reading other reviews I decided to go with this product to seal up the pipe on my 94 Sonoma between the manifold and converter. I wrapped the pipe with this and it’s holding up great! $15.00 bucks as apposed to the $160.00 for a new pipe and catalytic converter.

    0

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

DESC
7,45%
Walker 18899 SoundFX Muffler Reviews Precio $ 59.89
$ 55.43
Ahorra $4,46
DESC
41,53%
Heatshield Products 372400 Lava 4″ Wide x 100′ Roll Exhaust Wrap Precio $ 316.40
$ 185.00
Ahorra $131,40
DESC
47,33%
Dynomax 33226 Stainless Steel Hardware Clamp Band Precio $ 11.05
$ 5.82
Ahorra $5,23
DESC
19,46%
Walker 17911 Economy Pro-Fit Muffler Precio $ 23.59
$ 19.00
Ahorra $4,59
DESC
59,14%
Thrush 17711 Turbo Muffler Reviews Precio $ 61.18
$ 25.00
Ahorra $36,18
DESC
46,78%
BlueDEF DEF002 Diesel Exhaust Fluid – 2.5 Gallon Jug Precio $ 22.49
$ 11.97
Ahorra $10,52

Producto al azar

DESC
28,30%
DEA A5420 Front Engine Mount Precio $ 21.41
$ 15.35
Ahorra $6,06
DESC
70,85%
Pyle PLBT72G 7-Inch Single DIN In-Dash Motorized Touchscreen LCD Monitor with DVD/CD/USB/SD, AM/FM/Bluetooth, Built-In GPS with Maps Precio $ 668.99
$ 194.99
Ahorra $474,00